Introduction
CAUTION: Updating the firmware incorrectly or using an update on the wrong DVR can permanently damage the chip-set on the DVR and make it unusable. Please verify that this update is written for your model.
Firmware updates are released to resolve performance issues and/or to add features. Any update could fail and cause problems if the steps are not followed correctly, or if the update is not required.
If you are not experiencing an issue that the firmware update was written to resolve, or you do not need the feature that is added by the update, please do not run the update.
Cancel: I did not complete this guide.
3 other people completed this guide.
18 Comments
Been waiting for 1 hour and still saying loading is there smoothing I should do or just keep waiting?
it should not take 1 hour. I recommend you manually turn the DVR off and try to reboot, and retry.
DVR keeps rebooting. Shows loading screen then turn off for a few seconds. What do I need to do?
if the system fails to boot, try opening the system, and disconnecting the cables from the hard drive. then try to boot without the hard drive connected.
Ok. I tried that and it is still doing the same thing. It shows a loading screen. Then shuts off. Then loading screen again.