Skip to main content

2

by Q-See

Introduction

QCA CAMERAS SEND VIDEO SIGNALS IN A DIFFERENT FORMAT THAN STANDARD QTH CAMERAS. IF NOT CONFIGURED PROPERLY, IMAGES FROM QCA CAMERAS WILL APPEAR BLACK AND WHITE OR HAVE NO VIDEO.

''THIS GUIDE ONLY APPLIES TO DVR MODELS QTH85, QTH165, QTH94, QTH98, AND QTH916.

ONLY QCA CAMERAS UP TO 1080P RESOLUTION ARE SUPPORTED.''

  1. Click Start in the menu bar
    • Click Start in the menu bar

  2. Click Settings
    • Click Settings

  3. Click Camera
    • Click Camera

  4. Identify the channel your QCA camera is connected to.
    • Identify the channel your QCA camera is connected to.

    • Check the CVI box for your QCA camera.

    • Click Apply

  5. A message for Video Loss may appear, this is normal
    • A message for Video Loss may appear, this is normal

    • Click OK to clear the message.

    • The picture from the camera should appear normal.

Finish Line

Q-See EP

Member since: 12/13/2017

4,309 Reputation

24 Guides authored

5 Comments

Quick and speedy response to solve main problem… however I need complete QTH manual to understand the settings  terminology because it is very different than my old QCA918 unit…???

Mike Ritucci - Reply

Mike,

Here is the link to all the guides for this DVR. Tile Interface

There is no manual. The quick start guide is also found at the bottom of the page.

Q-See -

Is there an on line manual for the QTH98 dvr?

Mike Ritucci - Reply

I have a QTH98 with firmware 1.3.3 installed and it does not have the CVI box to check. The chart I found says that the QCA camera is compatible with this unit but it shows only black and white. Is there an updated procedure to get these to work?

Brandon - Reply

Click the drop down for signal, and choose CVI/CVBS

Q-See -

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 20

Past 30 Days: 130

All Time: 1,259