Skip to main content

2

by Q-See

Introduction

BY DEFAULT, YOUR SYSTEM IS SET FOR 24/7 MOTION DETECTION RECORDING.

  1. Click Start in the Menu Bar
    • Click Start in the Menu Bar

  2. Click Settings
    • Click Settings

  3. Click Motion in the Camera tile.
    • Click Motion in the Camera tile.

  4. Select the Camera you wish to enable.
    • Select the Camera you wish to enable.

    • Click Motion and select ON.

    • Repeat for any other cameras you wish to enable for motion.

  5. To modify the regions of the camera for motion detection:
    • To modify the regions of the camera for motion detection:

    • Refer to the Example to see how to add/remove regions.

    • Click and Drag the mouse in the camera view to make changes.

    • Repeat for any other cameras you wish to enable for motion.

  6. Once you have configured all of your cameras:
    • Once you have configured all of your cameras:

    • Click Apply

  7. To enable Motion Recording and configure the schedule:
    • To enable Motion Recording and configure the schedule:

    • Click Record in the top menu bar.

  8. Select Motion Record as the Record Mode.
    • Select Motion Record as the Record Mode.

  9. Advanced camera settings can be modified if required.
    • Advanced camera settings can be modified if required.

    • The default settings are optimized for the highest quality recording and streaming for your recorder. Changes to these settings should not be made unless you are an expert user, or were advised by a Q-See agent.

    • Click OK

  10. Click Apply
    • Click Apply

  11. Click Schedule Config
    • Click Schedule Config

  12. To modify the schedule for ALL cameras:
    • To modify the schedule for ALL cameras:

    • Click Motion Record Schedule and Select Edit.

  13. Click All to fill the schedule.
    • Click All to fill the schedule.

    • Clicking All will set your system to 24/7 motion recording. The following steps will show you how to refine the schedule.

  14. Click the Trashcan to remove specific times.
    • Click the Trashcan to remove specific times.

    • Click and Drag the mouse to make changes.

  15. Once completed, click OK
    • Once completed, click OK

  16. To modify the schedule for a specific camera:
    • To modify the schedule for a specific camera:

    • Click the Modify icon for the desired camera.

    • Follow the same process shown in Steps 13 thru 15 to make changes to cameras individually.

  17. Click Apply
    • Click Apply

  18. Once motion is detected by a camera:
    • Once motion is detected by a camera:

    • A Motion, instant, messenger icon indicator will appear next to the recording indicator.

    • Once motion is no longer detected, you will only see the recording indicator during post record.

Finish Line

One other person completed this guide.

Q-See EP

Member since: 12/13/2017

4,309 Reputation

24 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 6

Past 7 Days: 21

Past 30 Days: 81

All Time: 1,587