Introduction
BY DEFAULT, YOUR SYSTEM IS SET FOR 24/7 MOTION DETECTION RECORDING.
Select the Camera you wish to enable.
Click Motion and select ON .
Repeat for any other cameras you wish to enable for motion.
To modify the regions of the camera for motion detection:
Refer to the Example to see how to add/remove regions.
Click and Drag the mouse in the camera view to make changes.
Repeat for any other cameras you wish to enable for motion.
Advanced camera settings can be modified if required.
The default settings are optimized for the highest quality recording and streaming for your recorder. Changes to these settings should not be made unless you are an expert user, or were advised by a Q-See agent.
Click OK
To modify the schedule for a specific camera:
Click the Modify icon for the desired camera.
Follow the same process shown in Steps 13 thru 15 to make changes to cameras individually.
Once motion is detected by a camera:
A Motion , instant, messenger icon indicator will appear next to the recording indicator.
Once motion is no longer detected, you will only see the recording indicator during post record.
Embed this guide
Choose a size and copy the code below to embed this guide as a small widget on your site / forum.
Single Step
Full Guide
Small - 600px
Medium - 800px
Large - 1200px
Preview